Datalogger for current, voltage and binary signal

Data loggers are designed for record of voltage signal 0-5V (optionally 0-10V) or current signal 0-20mA. At the same time state of binary signal can be recorded.

E-mail link to a friend

Further product information.

included traceable calibration certificate from the manufacturer - Comet
fast data transfer to the PC (full memory for approximately 30s)
variability of connection to the computer - USB, RS232, Ethernet, GSM modem
permanent connection to the PC enabled, data is possible to download even during logging
large data memory 32000 values
large dual line display with special symbols, switchable
optional display of minimum and maximum measured values (reset of min/max memory from PC or by magnet)
dual level alarm is enabled for each channel, alarm is indicated by blinking of the value on the LCD display
two alarm modes are enabled: instant or with memory (detected alarm is indicated permanently till alarm memory is cleared)
robust watertight case
easy installation, locking enabled
low power consumption from battery, battery life up to 6 years
indication of remaining battery life, easy replacement of the battery
logging start/stop is enabled: at certain time and date programmed from computer, by external binary signal or by delivered magnet
also special logging mode is enabled, when logging runs only, if some of measured values are out of adjusted alarm limits
input signal is recalculated and displayed in real measured physical units by means of the PC software
each logger is possible to describe with text of maximum 32 characters
each channel is possible to describe with text of maximum 16 characters
password protection is enabled to prevent unauthorized manipulation with logger

Typ	LOGGERY S DISPLEJEM	Rozsah měření
S5011	Single channel voltage data logger	0-5Vdc + binary signal (0-10Vdc available as an option)
S5021	Dual channel voltage data logger. Input channels are not galvanic isolated and have common ground.	0-5Vdc + binary signal (0-10Vdc available as an option)
S6011	Single channel current data logger. The current loop should be powered from external power supply.	0-20mA + binary signal
S6021	Dual channel current data logger. The current loops should be powered from external power supply. Input channels are not galvanic isolated and have common ground.	0-20mA + binary signal

Request

Your request

Did you fail to find the information you were looking for, or do you have a specific request concerning this particular product?
Fill in our request form and we will contact you as soon as possible.